Shinybow USA SB-6335T Instruction Manual download pdf (Page 12)

EDID FUNCTION

EDID FUNCTION SETUP

EDID Setup How to enter and exit

ENTER EXIT

EDID EDID

1. ENTER : After the switcher is turned on, the screen shows the main

page. Press EDID to enter the EDID setup page.

2. SELECT : When you enter, EDID mode selection will show on the top.

DES is an abbreviation for destination while SRC for source.

Pressing source keys 1 and 2 enable you to select the 8 EDID modes. (See

page 11) Pressing destination keys will enter learning mode. (See page 12)

3. EXIT : Press EDID again to exit. If you exit before ENTER is pressed, the

setup will be cancelled.

If the right bottom corner shows lock, it means the front panel buttons are

all locked up. Pressing EDID when the panel is locked will not enter EDID

setup page.

EDID Setup How to select an EDID mode

EDID SOURCE #1 or #2 Enter

In the EDID setup page, pressing the source button 1 and 2 will cycle thru the available selections.

Pressing source button 1 repeatedly to cycle UP.

Pressing source button 2 repeatedly to cycle DOWN.

A total of 8 embedded EDID modes are provided for selection. (See page 11)

When the desired mode is displayed, press Enter to conﬁ rm that selection.

The selected EDID mode will be applied to all destination and source devices.

1. Enter the EDID setup page and press source button 1 or 2 to cycle

through the 8 embedded EDID modes.

2. The left shows mode 2 as example. See the line 2. H24-3D, PCM 2 CH.

To select the mode, press enter button.

To go to next mode, press source 2.

To return to previous mode, press source 1.

* Operation will abort if no buttons are pressed within 5 seconds.

View the current EDID mode

The lower left shows the currently selected EDID mode. The left shows the currently selected mode is mode 2, H24-3D, PCM 2 CH.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Shinybow USA SB-6335T Instruction Manual Page 12