Shinybow USA SB-6335T Instruction Manual download pdf (Page 11)

IR REMOTE CUSTOM AND DATA CODES (NEC STANDARD)

EDID Setup To change the EDID setup

Step 1. Press the EDID button The display will show the currently selected EDID mode

Step 2. Press SOURCE #1 or #2 button row The button will ash blue and the display will show the current Embedded

EDID Status.

Step 3. Press the ENTER button To set EDID mode. The switcher will return to operation mode.

Operation will abort if no keys are pressed within 5 seconds.

Embedded EDID modes Total 4 EDID Modes

Embedded EDID setup

Press

EDID > SOURCE > ENTER

SOURCE #1

SOURCE #2

To select Embedded EDID mode or LEARNING mode.

Press EDID button : The LCM will show the current EDID status.

Repeatedly depressing the source 1 button will cycle up thru the options.

Repeatedly depressing the source 2 button will cycle down thru the options.

Select Embedded EDID :

Mode 1 : FSS

Mode 2 : 1280x1024-60Hz

Mode 3 : 1920x1200-60Hz

Mode 4 : AUTO

EDID FUNCTION FOR DVI MATRIX SWITCHER

View the current EDID mode

Learning EDID setup

Press

EDID > DESTINATION > SOURCE > ENTER

Press EDID > DESTINATION Button:

The LCM will be show LEARNING

Switcher will LEARN destination EDID and pass the selected source.

NOTE : The already learned EDID cannot be modied. You can only rebuild a new Learning EDID.

For example;

When the Source has “Learned” the EDID data from a destination, It will save that EDID information into EPROM and the EDID data

cannot change. Please select new learning destination to sources or change to one of the embedded EDID modes when you want to

remove the learning EDID memory from EPRPM.

EDID FUNCTION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Shinybow USA SB-6335T Instruction Manual Page 11